Step 4. Remove the integrated diagnostics panel from its assembly.
Figure 57. LCD diagnostics panel removal
a. Press down the clips as shown.
b.
Pull the integrated diagnostics panel by its handle to get it out of its assembly.
After you finish
1. Install a new integrated diagnostics panel assembly or filler. See
“Install the integrated diagnostics panel
assembly” on page 106
.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the integrated diagnostics panel assembly
Use this information to install the diagnostics panel assembly.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Touch the static-protective package that contains the diagnostics panel assembly to any unpainted
surface on the outside of the server. And then, take the assembly out of the package and place it
on a static-protective surface.
106
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
