Step 5. Install the EDSFF drive cage cover.
Figure 80. EDSFF drive cage cover installation
After you finish
1. Reinstall the security bezel if you have removed it. See
“Install the security bezel” on page 215.
2. Use the Lenovo XClarity Provisioning Manager to configure the RAID if necessary. For more information,
see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_product_page.html
Demo video
Watch the procedure on YouTube
Hot-swap power supply unit replacement
Use this information to remove and install a hot-swap power supply unit.
Remove a hot-swap power supply unit
Use this information to remove a power supply unit.
About this task
If the power supply unit to be removed is the only one installed, the power supply unit is not hot-swappable.
Before removing it, you must turn off the server first. To support redundancy mode or hot-swap, install an
additional hot-swap power supply unit.
Safety information for AC power supplies
Chapter 5. Hardware replacement procedures 123
To Next Page
Loading...
