Figure 244. Mapping between the rear NVMe backplane signal cable and the processor board
3 From NVMe 0, 1 to PCIe 7
Cable routing for backplane power
Use the section to understand the power cable routing for both front and rear drive backplanes.
• The backplanes your server supports require power connection. This section singles out the power
connection from signal connection for better understanding.
• For the locations of backplane power connectors on the processor board, see
“Processor-board
connectors for cable routing” on page 257
for details.
• For more information about backplanes supported and their connectors, see
“Drive backplane
connectors” on page 250
.
274
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
