Install the external LCD cable (4 x 3.5'' chassis)
Use this information to install the external LCD cable.
In the 4 x 3.5'' chassis configuration, the external LCD cable is an optional part. You can choose either install
or remove the cable according to your actual needs. Refer to the location of external LCD cable from the
front view as below:
1 The external LCD cable connector
Figure 66. A front view with the cable installed
1 A filler for external LCD cable connector
Figure 67. A front view with a filler installed
Note: Before installing the cable, remove the filler first; after removing the cable, install the filler afterwards.
About this task
The following illustrates how to remove the external LCD cable from the chassis.
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Touch the static-protective package that contains the external LCD cable to any unpainted surface
on the outside of the server. Then, take the external LCD cable out of the package and place it on a
static-protective surface.
Chapter 5. Hardware replacement procedures 111
To Next Page
Loading...
