Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the front I/O module to any unpainted surface on
the outside of the server. Then, take the front I/O module out of the package and place it on a
static-protective surface.
Step 2. Install the front I/O module.
Figure 54. Install a front I/O module on 2.5'' chassis
Figure 55. Install a front I/O module on 3.5'' chassis
a.
Insert the front I/O module into the front chassis.
b.
Install the screws to secure the front I/O module in place.
After you finish
1. Connect the front I/O cables to the processor board. See
“Front I/O module” on page 262.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
Remove the integrated diagnostics panel assembly
Use this information to remove the integrated diagnostics panel assembly.
About this task
Attention:
104 ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
