Demo video
Watch the procedure on YouTube
EDSFF cage replacement
Use this information to remove and install an EDSFF cage
Remove an EDSFF cage
Use this information to remove an EDSFF cage.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. If the security bezel is installed, remove it first. See
“Remove the security bezel” on page 213.
Step 2. Locate the EDSFF cage you need to remove, and then remove all the EDSFF drives installed in it.
See
“Remove a hot-swap EDSFF drive” on page 119.
Chapter 5. Hardware replacement procedures 99
To Next Page
Loading...
