Remove the MicroSD card
Follow the instructions in this section to remove the MicroSD card.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See
“Remove the top cover” on page 243.
b. If your server comes with riser assemblies, remove them first, see
“Remove a PCIe adapter” on
page 170
.
c. If your server comes with a rear drive assembly, remove it first. See
“Remove the 2.5-inch rear
drive assembly” on page 198
.
d. If your server comes with a 7mm rear drive assembly, remove it first. See “Remove the 7mm
rear drive assembly” on page 202
.
e. Record where the cables are connected to the system board assembly; then, disconnect all
the cables.
Attention: Disengage all latches, cable clips, release tabs, or locks on cable connectors
beforehand. Failing to release them before removing the cables will damage the cable
connectors on the system board assembly. Any damage to the cable connectors may require
replacing the system board assembly.
Step 2. Remove the MicroSD card.
154
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
