After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the RAID flash power module on the air baffle
Use this information to install the RAID flash power module on the air baffle.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Touch the static-protective package that contains the RAID flash power module to any unpainted
surface on the outside of the server. Then, take the RAID flash power module out of the package
and place it on a static-protective surface.
Step 2. Install the RAID flash power module on the air baffle.
Figure 132. Installation of the RAID flash power module on the air baffle
a. Open the retention clip on the holder.
b.
Put the RAID flash power module into the air baffle and press it down to secure it into the air
baffle.
Chapter 5. Hardware replacement procedures 195
To Next Page
Loading...
