2. Complete the parts replacement. See “Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
Remove the RAID flash power module on the air baffle
Use this information to remove the RAID flash power module on the air baffle.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 243.
Step 2. Disconnect the cable of the RAID flash power module.
Step 3. Remove the air baffle from the chassis. See “Remove the air baffle” on page 77.
Step 4. Remove the RAID flash power module on the air baffle.
Figure 131. Removal of the RAID flash power module on the air baffle
a.
Open the retention clip on the holder of the RAID flash power module.
b.
Take the RAID flash power module out of the holder.
194 ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
