b. “Install the 7mm rear drive assembly” on page 203
c. “Install the 2.5-inch rear drive assembly” on page 199
d. “Install the top cover” on page 244
2. Complete the parts replacement. See “Complete the parts replacement” on page 246.
M.2 backplane and M.2 drive replacement
Use this information to remove and install the M.2 backplane and M.2 drive (an assembled M.2 backplane
and M.2 drive is also known as M.2 module).
Remove the M.2 backplane and M.2 drive
Use this information to remove the M.2 backplane and M.2 drive.
About this task
Attention:
• Read “Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 243.
Chapter 5. Hardware replacement procedures 157
To Next Page
Loading...
