6 x 2.5'' SAS/SATA + 4 x 2.5'' AnyBay (liquid cooling)
Use this section to understand the cable routing of six SAS/SATA front drives and four AnyBay front drives
for liquid cooling configuration with the 6 x 2.5'' SAS/SATA and 4 x 2.5'' AnyBay front backplane installed.
To connect power cables for a backplane for standard 2.5-inch or 3.5-inch drives, refer to “Cable routing for
backplane power” on page 274
.
To connect cables for a 7mm drive backplane, refer to
“7mm drive backplane” on page 270.
To connect signal cables for a backplane for standard six SAS/SATA and four AnyBay front drives, refer to
the following cable routing scenarios depending on your server configuration:
•
“Cable routing for onboard configuration” on page 277
• “Cable routing with an SFF HBA/RAID adapter” on page 279
Cable routing for onboard configuration
The following illustrations and tables show the mapping relationship between backplane connectors and
processor board connectors for onboard configuration.
The following figure illustrates the cable routing for the configuration of six SAS/SATA and four AnyBay front
drives bays. Connections between connectors: 1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n .
Chapter 6. Internal cable routing 277
To Next Page
Loading...
