• The two pump cables and one cable for the leakage detection sensor module are integrated to the LACM,
make sure that all three cables are connected.
Note: For better cable arrangement, it is required to install the liquid detection sensor module to a
designated holder, and make sure that the module is secured in holder clips. Use the illustration below or
“Install the Lenovo Neptune(TM) liquid assisted cooling module” on page 143 for details.
Liquid assisted cooling module cable routing
Cable From To
1 Pump 1 Pump 1 cable Pump 1 connector
2 Pump 2 Pump 2 cable Pump 2 connector
3 Leak detection Leak detection cable Leak detection connector
With the LACM installed, your server supports below drive combinations:
276
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
