Figure 176. Rear wall bracket removal
Demo video
Watch the procedure on YouTube
Install a riser card
Use this information to install a riser card.
About this task
For more riser brackets supported, see “Riser card replacement” on page 204.
The riser assembly you want to install might be different from the following illustrations, but the installation
method is the same. The following takes the LP-FH riser assembly as an example.
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the riser card to any unpainted surface on the
outside of the server. Then, take the riser card out of the package and place it on a static-protective
surface.
Chapter 5. Hardware replacement procedures 211
To Next Page
Loading...
