CFF RAID adapter
Use the section to understand the power cable and signal input cable routing for CFF RAID adapters.
Cable routing for CFF RAID adapters
• For the locations of connectors on CFF RAID adapters and the processor board, see
“RAID and HBA
adapter connectors” on page 254
and “Processor-board connectors for cable routing” on page 257 for
details.
• For more information about the CFF RAID adapters supported, see
“RAID adapter” on page 8.
• The table below presents that how the power cables and MB input cables are connected with one and two
processors installed. Find more connections in different configuration at
“Cable routing for backplane
signals (one processor)” on page 298
and “Cable routing for backplane signals (two processors)” on page
350
.
•
“Cable routing for Gen 4 CFF RAID adapters” on page 261
• “Cable routing for Gen 3 CFF RAID adapters” on page 262
260
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
