Step 2. Put the backplane down into place.
Figure 35. Installation of backplane for four 3.5-inch hot-swap drives
a.
Put the backplane under the front I/O assembly cables, align it with the chassis, and lower it
into the chassis. Put the backplane into place with it leaning backward slightly so that the three
pins
1 on the chassis pass through the three holes 2 in the backplane.
b.
Close the release latches to secure the backplane in place.
Step 3. Connect the cables to the system board assembly and the backplane. See
Chapter 6 “Internal
cable routing” on page 249
. If the cable connectors come with protective dust caps, make sure to
remove them before plugging in.
After you finish
1. Reinstall all the drives and drive fillers into the drive bays. See
“Install a 2.5/3.5-inch hot-swap drive” on
page 117
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Remove the front 16-EDSFF drive backplane
Use this information to remove the backplane for front 16 EDSFF drives.
About this task
Attention:
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
