Demo video
Watch the procedure on YouTube
Install the rack latches
Use this information to install the rack latches.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the rack latches to any unpainted surface on the
outside of the server. Then, take the rack latches out of the package and place them on a static-
protective surface.
Step 2. Install the rack latch.
Figure 123. Rack latch installation
a. On each side of the server, align the rack latch with the pin on the chassis. Then, press the
rack latch onto the chassis and slightly slide it forward as shown.
b.
Install the two screws to secure the rack latch on each side of the server.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
188
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
