• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the internal CFF RAID adapter to any unpainted
surface on the outside of the server. Then, take the internal CFF RAID adapter out of the package
and place it on a static-protective surface.
Step 2. Align the notches on the tray with the pins on the chassis, place down the internal CFF RAID
adapter, and slightly slide it as shown to secure it on the chassis.
Figure 87. internal CFF RAID adapter installation
Step 3. Connect cables to the internal RAID adapter. See
“CFF RAID adapter” on page 260.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
Intrusion switch replacement
Use this information to remove and install an intrusion switch.
The intrusion switch informs you that the server cover is not properly installed or closed by creating an event
in the system event log (SEL).
Remove an intrusion switch
Use this information to remove an intrusion switch.
About this task
Chapter 5. Hardware replacement procedures 135
To Next Page
Loading...
