Figure 72. Install a drive filler
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install a 2.5/3.5-inch hot-swap drive
Use this information to install a 2.5/3.5-inch hot-swap drive.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the drive to any unpainted surface on the outside
of the server. And then, take the drive out of the package and place it on a static-protective surface.
Note: Ensure that drive installation meets
“Technical rules for drives” on page 64.
Step 2. Remove the drive filler from the drive bay and keep the drive filler in a safe place.
Chapter 5. Hardware replacement procedures 117
To Next Page
Loading...
