Figure 91. Removing MicroSD card
a.
Slide the socket lid to OPEN position.
b.
Lift open the socket lid.
c.
Remove the MicroSD card from the socket.
Note: After the MicroSD card is removed, the historical data of the firmware and user data
uploaded through Remote Disc On Card (RDOC) will be lost, and the firmware rollback function and
extended RDOC space will not be supported. To enable the two features, it will need to install a
new MicroSD card.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the MicroSD card
Follow the instructions in this section to install the MicroSD card.
About this task
Attention:
• Read “Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 155
To Next Page
Loading...
