Lenovo ThinkSystem SR630 V3 - Heat Sink Torx T30 Nut Replacement; Remove a Heat Sink Torx T30 Nut

Step 2. Install the external LCD cable.
Figure 68. Installation of the external LCD cable
Note: The front and back sides of the connector to external diagnostics slot are different, and it is
required to plug in with the front side.
When plugging in, face the front side upward and slide the connector into the chassis. Refer to the
illustration above.
After you finish
1. Connect the external LCD cable to the processor board. See
Chapter 6 “Internal cable routing” on page
249
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Heat sink Torx T30 nut replacement
Use this information to remove and install a heat sink Torx T30 nut.
Remove a heat sink Torx T30 nut
This task has instructions for removing a PEEK (Polyether ether ketone) Torx T30 nut on the heat sink.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
112
ThinkSystem SR630 V3 User Guide