Step 4. Install the memory module into the slot.
Figure 90. Memory module installation
Attention:
• Before you install a memory module into the slot, make sure that the clips are on open position,
and the slot is clear of any debris.
• To avoid breaking the retaining clips or damaging the memory module slots, open and close the
clips gently.
a.
Open the retaining clip on each end of the memory module slot.
b.
Identify the key on the memory module and then align the key to the slot, and gently place
the memory module into the slot with both hands.
c.
Press both ends of the memory module straight down into the slot until the retaining clips
snap into the locked position.
Note: If there is a gap between the memory module and the retaining clips, the memory
module has not been correctly inserted. In this case, open the retaining clips, remove the
memory module, and then reinsert it.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
MicroSD card replacement
Follow the instructions in this section to remove and install the MicroSD card.
Chapter 5. Hardware replacement procedures 153
To Next Page
Loading...
