Demo video
Watch the procedure on YouTube
Remove the 2.5-inch rear drive backplane
Use this information to remove the 2.5-inch rear drive backplane.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See
“Remove the top cover” on page 243.
b. Remove all installed drives and fillers (if any) from the drive bays. See
“Remove a 2.5/3.5-inch
hot-swap drive” on page 115
.
88
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
