Step 2. Gently press and hold the tab on the rear hot-swap drive cage as shown and remove the air baffle
from the rear hot-swap drive cage.
Figure 38. Air baffle removal
a. Press the tab on one side to disengage the air baffle.
b.
Lift the air baffle to remove it from drive cage.
Step 3. Record the cable connections for 2.5–inch rear drive and then disconnect all cables from the
backplanes. For information about the backplane cable routing, see
Chapter 6 “Internal cable
routing” on page 249
.
Step 4. Carefully lift the 2.5-inch rear drive backplane out of the rear hot-swap drive cage.
Figure 39. 2.5-inch rear drive backplane removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Chapter 5. Hardware replacement procedures 89
To Next Page
Loading...
