Step 4. Slide the diagnostics panel assembly into the front chassis as shown. And ensure that it is seated in
place.
Figure 60. Diagnostics panel assembly installation
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 246.
Remove the external LCD cable (4 x 3.5'' chassis)
Use this information to remove the external LCD cable.
In the 4 x 3.5'' chassis configuration, the external LCD cable is an optional part. You can choose either install
or remove the cable according to your actual needs. Refer to the location of external LCD cable from the
front view as below:
1 The external LCD cable connector
Figure 61. A front view with the cable installed
1 A filler for external LCD cable connector
Figure 62. A front view with a filler installed
Note: Before installing the cable, remove the filler first; after removing the cable, install the filler afterwards.
About this task
The following illustrates how to remove the external LCD cable from the chassis.
Attention:
108
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
