Lenovo ThinkSystem SR630 V3 - Remove the RAID Flash Power Module on the Riser

After you finish
1. Install the air baffle on the chassis. See “Install the air baffle” on page 78.
2. Connect the flash power module to an adapter with the extension cable that comes with the flash power
module. See
“RAID flash power modules” on page 264.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Remove the RAID flash power module on the riser
Use this information to remove the RAID flash power module on the riser.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 243.
Step 2. Disconnect the cable of the RAID flash power module.
Step 3. Remove the riser assembly. See “Remove a riser card” on page 208.
196
ThinkSystem SR630 V3 User Guide