A video of this procedure is available on YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Note: The M.2 backplane you want to adjust might be different from the following illustrations, but the
adjustment method is the same.
Figure 95. M.2 retainer adjustment
Step 1. Press both sides of the retainers.
Step 2.
Move the retainer forward until it is in the large opening of the keyhole.
Step 3.
Take the retainer out of the keyhole.
Step 4.
Insert the retainer into the correct keyhole into which the retainer should be installed to
accommodate the particular size of the M.2 drive you wish to install.
Step 5.
Press both sides of the retainer.
Step 6.
Slide the retainer backwards until it is seated in place.
Install the M.2 backplane and M.2 drive
Use this information to install the M.2 backplane and M.2 drive.
About this task
Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the M.2 backplane and M.2 drive to any
unpainted surface on the outside of the server. Then, take the M.2 backplane and M.2 drive out of
the package and place them on a static-protective surface.
160
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
