Note: The M.2 backplane you want to install might be different from the following illustrations, but
the installation method is the same.
Step 2. Adjust the retainer on the M.2 backplane to accommodate the particular size of the M.2 drive you
wish to install. See
“Adjust the retainer on the M.2 backplane” on page 159.
Step 3. Locate the M.2 drive slot on the M.2 backplane.
Note: For some M.2 backplanes that support two identical M.2 drives, install the M.2 drive in slot 0
first.
Figure 96. M.2 drive slot
1 Slot 0
2 Slot 1
Step 4. Install the M.2 backplane onto the chassis.
Figure 97. M.2 backplane installation
a. Align the notch of the M.2 backplane with the pin on the chassis, and then place down the
M.2 backplane.
b.
Tighten the screw to secure the M.2 backplane.
Chapter 5. Hardware replacement procedures 161
To Next Page
Loading...
