After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 246.
Demo video
Watch the procedure on YouTube
Rack latches replacement
Use this information to remove and install the rack latches.
Remove the rack latches
Use this information to remove the rack latches.
About this task
Attention:
• Read “Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. If the server is installed with the security bezel, remove it first. See
“Remove the security bezel” on
page 213
.
Step 2. Remove the rack latch.
Figure 122. Rack latch removal
a. On each side of the server, remove the two screws that secure the rack latch.
b.
On each side of the server, remove the rack latch from the chassis as shown.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Chapter 5. Hardware replacement procedures 187
To Next Page
Loading...
