Table 84. Mapping between one front AnyBay backplane, the processor board and a re-timer adapter (continued)
Backplane From To
3 NVMe 4–5
3 C0
Front BP (SAS)
4 SAS 1 4 SATA 1
Front BP (NVMe)
5 NVMe 6–7
5 C1
10 x 2.5'' front drives (one processor)
Use the section to understand the cable routing for signal cable connections for 10 x 2.5'' front drive
backplanes when one processor installed.
6 x 2.5'' SAS/SATA + 4 x 2.5'' AnyBay (one processor)
See this section to understand the cable routing of 6 front SAS/SATA drives and 4 front AnyBay drives with 6
x 2.5'' SAS/SATA + 4 x 2.5'' AnyBay backplane installed.
To connect cables for a 7mm drive backplane, refer to
“7mm drive backplane” on page 270.
To connect power cables for a backplane for standard 2.5-inch or 3.5-inch drives, refer to
“Cable routing for
backplane power” on page 274
.
To connect cables for M.2 drives, refer to
“M.2 drive backplane” on page 267.
To connect signal cables for a backplane for standard 6 front SAS/SATA drives and 4 front AnyBay drives,
refer to the following cable routing scenarios depending on your server configuration:
•
“Cable routing for onboard configuration” on page 331
• “Cable routing with an SFF HBA/RAID adapter” on page 333
Cable routing for onboard configuration
The following tables show the mapping relationship between backplane connectors and processor board
connectors for onboard configuration.
The following figure illustrates the cable routing for the configuration of 6 front SAS/SATA drives and 4 front
AnyBay drives bays. Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n .
Chapter 6. Internal cable routing 331
To Next Page
Loading...
