• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
• To ensure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a drive filler installed in each bay.
Procedure
Step 1. If the security bezel is installed, remove it first. See
“Remove the security bezel” on page 213.
Step 2. Remove a hot-swap drive.
Figure 71. Remove a hot-swap drive
a. Slide the release latch to the left to open the drive tray handle.
b.
Open the drive handle.
c.
Slide the drive out of the drive bay.
After you finish
1. Install a drive filler or a new drive to cover the drive bay.
116
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
