• Read “Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Watch the procedure
A video of this procedure is available on YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 243.
Step 2. If the security bezel is installed, remove it. See
“Remove the security bezel” on page 213.
Step 3. Remove the integrated diagnostics panel assembly from the chassis.
Figure 56. Integrated diagnostics panel assembly removal
a. Press down the extended tab on the other side of the front chassis.
b.
Slide the assembly out of the front chassis.
Chapter 5. Hardware replacement procedures 105
To Next Page
Loading...
