Step 5. Remove the external LCD cable.
Figure 64. Removal of the external LCD cable
a. Poke the connector latch with the tip of a flat-blade screwdriver (3 or 4 mm) to disengage
the connector from the chassis.
b.
Pull out the cable from the back side.
Step 6. Install the front I/O module back to the chassis.
Figure 65. Front I/O module installation
a.
Insert the front I/O module into the front chassis.
b.
Install the screws to secure the front I/O module in place.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
110
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
