• The onboard connection of rear NVMe drive backplane are different based on whether one or two
processors installed.
• For the locations of rear NVMe drive backplane connectors on the processor board, see
“Processor-
board connectors for cable routing” on page 257
for details.
Figure 242. Rear NVMe backplane cable routing with two
processors installed
Figure 243. Rear NVMe backplane cable routing with one
processor installed
1 From NVMe 0, 1 to PCIe 6 2 From NVMe 0, 1 to PCIe 1
Rear NVMe backplane cable routing with 10 x 2.5'' AnyBay backplane (Gen 5) installed
Note: With the 10 x 2.5'' AnyBay backplane (Gen 5) installed, the rear NVMe connection to the processor
board is different from other customary configuration.
Chapter 6. Internal cable routing 273
To Next Page
Loading...
