a. Disconnect the cable of the intrusion switch from the processor board. For the location of
the intrusion switch connector and cable routing information, refer to
“System-board-assembly
connectors” on page 36
and “Intrusion switch” on page 263. Route the cable out of the cable
clip.
b.
Insert the tip of a slotted screwdriver into the gap between the cage and switch and push
outwards.
c.
Slide the intrusion switch as shown to remove it.
Step 4. Re-install the system fan 4.
a. Align the four corners of the fan to fan module socket and put it down.
b.
Press the fan latch down to ensure that it is plugged in the connector.
After you finish
Chapter 5. Hardware replacement procedures 137
To Next Page
Loading...
