a. Insert the intrusion switch into the cage.
b.
Route the cable into the cable clip.
Step 4. Connect the cable of the intrusion switch to the intrusion switch connector on the processor board.
See “Intrusion switch” on page 263.
Step 5. Re-install the system fan 4.
a. Align the four corners of the fan to fan module socket and put it down.
b.
Press the fan latch down to ensure that it is plugged in the connector.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Chapter 5. Hardware replacement procedures 139
To Next Page
Loading...
