Step 3. Disconnect the pump 1 cable of the LACM from the connector on the system board assembly. See
“Liquid assisted cooling module” on page 275.
Step 4. Re-install the system fan 5 into the fan module.
a. Align the four corners of the fan to fan module socket and put it down.
b.
Press the fan latch down to ensure that it is plugged in the connector.
Step 5. Disconnect the leak detection cable from the processor board, and route it out of the cable clips on
the liquid detection sensor module holder.
Chapter 5. Hardware replacement procedures 141
To Next Page
Loading...
