A video of this procedure is available on YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-
CfNsWy-689CRZHExrZEi9I
.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 243.
Step 2. Install the power-supply-unit air baffle.
Figure 109. Power-supply-unit air baffle installation
a. Align the screw holes on the air baffle and the chassis, and put the air baffle down.
b.
Tighten the screw and ensure that the air baffle is secured in place.
After you finish
• Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component in
Chapter 6 “Internal cable routing” on page 249.
• Complete the parts replacement. See
“Complete the parts replacement” on page 246.
Chapter 5. Hardware replacement procedures 175
To Next Page
Loading...
