7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink
Torque screwdriver type list
Screw Type
Torx T30 head screwdriver Torx T30 screw
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover. See
“Remove the top cover” on page 243.
Step 2. If the processor comes with a T-shaped heat sink, fully loosen the two heat sink screws as shown.
Figure 111. Loosening T-shaped heat sink screws
Step 3. Remove the PHM from the processor board.
Figure 112. Removing a PHM
178 ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
