Attention:
• Read
“Installation Guidelines” on page 51 and “Safety inspection checklist” on page 52 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 68.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding systems.
Procedure
Step 1. Touch the static-protective package that contains the RAID flash power module to any unpainted
surface on the outside of the server. Then, take the RAID flash power module out of the package
and place it on a static-protective surface.
Step 2. If the server comes with a tray that covers the place of the RAID flash power module on the chassis,
remove it first.
Figure 128. Tray removal
a. Press the blue touch point to disengage the tray from the chassis.
b.
Move the tray to the direction as shown and lift it out of the chassis.
192
ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
