Step 2. Remove the system board assembly from the chassis.
Figure 196. System board assembly removal
a. Hold the lift handle
1 and lift the release pin 2 at the same time and slide the system board
assembly toward the front of the server.
b. Lift the system board assembly out of the chassis.
Step 3. Remove the Firmware and RoT Security module, see
“Remove the Firmware and RoT Security
Module” on page 223
.
Step 4. Remove the system I/O board, see
“Remove the system I/O board” on page 229.
Figure 197. The processor board
Note: The processor board comes with a supporting metal sheet. No further removal is needed.
After you finish
Important: Before you return the system board assembly, make sure that the processor socket is covered.
There is a processor external cap covering the processor socket on the new system board assembly. Slide
Chapter 5. Hardware replacement procedures 235
To Next Page
Loading...
