1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component in
Chapter 6 “Internal cable routing” on page 249.
3. After the cables are properly routed, make sure to close the sponge cable clips.
Figure 204. Close the sponge cable clips
4. If you have removed the top cover, reinstall it. See “Install the top cover” on page 244.
5. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect the power cords last.
Chapter 5. Hardware replacement procedures 247
To Next Page
Loading...
