Figure 240. Cable routing for 7mm drives
From To
1 Power port on the 7mm solid-state drive
1 Left: rear hard drive power connector
1 Right: rear hard drive sideband connector
2 Signal port on the 7mm solid-state drive 2–1 PCIe 8 (for NVMe signal, connected when two
processors are installed)
2–2 7mm/M.2 signal port on the processor board (for
SATA signal)
2–3 PCIe 1 (for NVMe signal, connected when one
processor is installed)
Chapter 6. Internal cable routing 271
To Next Page
Loading...
