To connect power cables for a backplane for standard 2.5-inch or 3.5-inch drives, refer to “Cable routing for
backplane power” on page 274
.
The following illustration and table show the cabling between the backplane and processor board for
onboard configuration.
Figure 262. Onboard cabling of 10 NVMe drives for liquid cooling
Table 57. Mapping between one front AnyBay backplane and processor board for onboard configuration
Backplane From To
Front BP (NVMe)
1 NVMe 0–1
1 PCIe 5
2 NVMe 2–3
2 PCIe 3
3 NVMe 4–5
3 PCIe 4
Chapter 6. Internal cable routing 297
To Next Page
Loading...
