Cable routing for onboard configuration
The following table shows the mapping relationship between backplane connectors and processor board
connectors for onboard configuration.
The following figure illustrates the cable routing for the onboard configuration of 4 x 3.5-inch front SAS/SATA
drive bays. Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n .
Figure 263. Cable routing for onboard configuration of 4 x 3.5-inch front SAS/SATA drive bays
Table 58. Mapping between one front SAS/SATA backplane and processor board for onboard configuration
Backplane From To
1 Front BP (SAS) SAS SATA 0
Chapter 6. Internal cable routing 299
To Next Page
Loading...
