• Gen 3 and Gen 4 SFF HBA/RAID adapters are slightly different in their connectors, but the cable routing
method is similar.
• To connect cables for RAID flash power module, refer to
“RAID flash power modules” on page 264.
The following table shows the mapping relationship between backplane connectors and processor board/
adapter connectors when an 8i SFF HBA/RAID adapter (Gen 3) is installed.
Figure 266. Cable routing for 4 x 3.5-inch front SAS/SATA drive bays with an 8i SFF RAID adapter (Gen 3) and rear 2 x
2.5–inch SAS/SATA drives
302 ThinkSystem SR630 V3 User Guide
To Next Page
Loading...
