4 x 3.5'' AnyBay backplane (one processor)
Use this section to understand the AnyBay backplane cable routing for server model with four 3.5-inch front
drives.
To connect cables for a 7mm drive backplane, refer to
“7mm drive backplane” on page 270.
To connect power cables for a backplane for standard 2.5-inch or 3.5-inch drives, refer to
“Cable routing for
backplane power” on page 274
.
To connect cables for M.2 drives, refer to
“M.2 drive backplane” on page 267.
To connect signal cables for a backplane for standard 4 x 3.5-inch front drives, refer to the following cable
routing scenarios depending on your server configuration:
•
“Cable routing for onboard configuration” on page 306
• “Cable routing with an SFF HBA/RAID adapter” on page 307
Chapter 6. Internal cable routing 305
To Next Page
Loading...
