Figure 293. Cable routing for 6 SAS/SATA drives and 2 AnyBay drives and 2 NVMe front drive bays with an 8i or 16i SFF
RAID adapter (Gen 3)
Table 93. Mapping between one front AnyBay backplane and an SFF HBA/RAID adapter
Backplane From To
Front BP (SAS)
1 SAS 0, SAS 1 1 C0, C1
Front BP (NVMe)
2 NVMe 2–3, 0–1
2 PCIe 1, 2
10 x 2.5'' SAS/SATA (one processor)
See this section to understand the cable routing of 10 front SAS/SATA drives with the 10 x 2.5 AnyBay
backplane (Gen 4) installed.
To connect cables for a 7mm drive backplane, refer to
“7mm drive backplane” on page 270.
Chapter 6. Internal cable routing 341
To Next Page
Loading...
