Table 110. Cable routing for onboard configuration of 4 x 3.5-inch front AnyBay drive bays with 2 x 2.5 rear SAS/SATA
drives
SAS/SATA cable routing NVMe cable routing
1 SAS
Front BP
SATA 0
NVMe
connector
From To
2 SAS Rear BP SATA 2
1 2–3, 0–1 Front BP PCIe 1, PCIe 2
Cable routing with an SFF HBA/RAID adapter
The following table shows the mapping relationship between backplane connectors and processor board/
adapter connectors when an 8i SFF HBA/RAID adapter (Gen 3 or Gen 4) is installed.
Chapter 6. Internal cable routing 361
To Next Page
Loading...
