Server model with two 7mm hot-swap rear drive bays and two PCIe slots
The following illustration shows the rear view of the server model with two 7mm hot-swap rear drive bays and
two PCIe slots. Depending on the model, your server might look slightly different from the illustration below.
Table 18. Components on the rear of the server
1 PCIe slot 1 on riser 1 assembly 2 PCIe slot 2 on riser 1 assembly
3 Rear 7mm drive bays (2) 4 Power supply 2 (optional)
5 Power supply 1 6 NMI button
7 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 8 VGA connector
9 XClarity Controller network connector 10 Ethernet connectors on OCP module (optional, two or
four connectors may be available)
Note: For more information about each component, see “Rear components overview” on page 30.
Server model with two 7mm hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two 7mm hot-swap rear drive bays and
one PCIe slots. Depending on the model, your server might look slightly different from the illustration below.
Table 19. Components on the rear of the server
1 PCIe slot 1 on riser 1 assembly 2 Rear 7mm drive bays (2)
3 Power supply 2 (optional)
4 Power supply 1
5 NMI button
6 VGA connector
7 USB 3.2 Gen 1 (5Gbps) connectors (3 DCIs) 8 XClarity Controller network connector
9 Ethernet connectors on OCP module (optional, two or
four connectors may be available)
Note: For more information about each component, see
“Rear components overview” on page 30.
Chapter 2. Server components 29
To Next Page
Loading...
