With a 10 x 2.5'' AnyBay backplane (Gen 4), following front drive combinations are supported:
10 x 2.5'' AnyBay
See this section to understand the cable routing of 10 front AnyBay drives with the 10 x 2.5'' AnyBay
backplane (Gen 4) installed.
To connect cables for a 7mm drive backplane, refer to
“7mm drive backplane” on page 270.
To connect power cables for a backplane for standard 2.5-inch or 3.5-inch drives, refer to
“Cable routing for
backplane power” on page 274
.
To connect cables for M.2 drives, refer to
“M.2 drive backplane” on page 267.
Cable routing with an SFF HBA/RAID adapter
The following tables show the mapping relationship between backplane connectors and an SFF HBA/RAID
adapter (Gen 3 or Gen 4).
Chapter 6. Internal cable routing 405
To Next Page
Loading...
